Hello all. Please forgive me if this is in the wrong section.
I've had my Provari for about 2 years now and just decided I was tired of cartomizers so I purchased a genuine kayfun Lite Plus. It arrived today and after a few "OP" error messages on the Provari, I got the coil to fire (28g, 8/9 wraps, 1.4ohms, organic cotton wick).
The first thing I notice is that it takes a good 1.5–2 seconds holding the button before the coil starts glowing and producing vapor. I have the Provari set to 3.7 volts and get an "E2" error if I try to go any higher than that. I'm used to vaping cartos at 6v on the Provari, and the kayfun feels about the same and produces the same amount of vapor. How can I get more kick from this setup? Do I need to go for a higher ohm build? The build is wicking perfectly, but I would like a little more heat and vapor if possible. Please forgive my ignorance, this is all new to me and I've struggled to find an answer.
Thank you in advance!
I've had my Provari for about 2 years now and just decided I was tired of cartomizers so I purchased a genuine kayfun Lite Plus. It arrived today and after a few "OP" error messages on the Provari, I got the coil to fire (28g, 8/9 wraps, 1.4ohms, organic cotton wick).
The first thing I notice is that it takes a good 1.5–2 seconds holding the button before the coil starts glowing and producing vapor. I have the Provari set to 3.7 volts and get an "E2" error if I try to go any higher than that. I'm used to vaping cartos at 6v on the Provari, and the kayfun feels about the same and produces the same amount of vapor. How can I get more kick from this setup? Do I need to go for a higher ohm build? The build is wicking perfectly, but I would like a little more heat and vapor if possible. Please forgive my ignorance, this is all new to me and I've struggled to find an answer.
Thank you in advance!