I built my first coil on my rsst but have a problem. My Vamo (v2) says it's 2.5ohms and fires but my S.I.D. reads 9.9ohms and won't fire. Any clues as to what i did wrong?
Usually a 9.9 means that there is a short or no atty attached to device. If no short is present (since it read on your Vamo) then its probably what dash said and is a center pin/connection issue.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.