Nimbus Dripping Atomizer Newbie

[vexinho]

Hello everyone!

Its been a while since I've posted so I'm happy to see everyone again. I just went down to a local E-Cig store in my area
and purchased the iTaste MVP 2.0 and the Nimbus Dual Coil Dripping Atomizer! Now, I've strictly been a Protank and iClear kinda guy the whole time I've been vaping with my trusty Vamo v2. My question to you is, how do I go about dripping into this bad boy? It already has a wick attached to it so I do not need to build it from the get go, but just not sure how to drip, which whole to drip in, how much to drip etc... If someone can help me out that would be great! I'm new to the dripping experience and can't wait to start!

Thanks!

 

[JBL-37]

You may want to give it a thorough wash first... You can drip through the tip or remove the tip and drip. I'd fill it with about 15-20 drops to start and let it sit for a few minutes. Take a look and make sure it's all saturated before vaping. You'll know when it's time to add more juice when the flavor starts to change. Will not take as many drops to refill as it did to start out. Maybe 5-10, depends on amount of wick inside the atty.

Get ready for the flavor explosion . Happy vaping!

 

[vexinho]

Thanks for the quick response!

I watched a youtube video about the Nimbus and I seen that the guy in the video had the whole chamber almost filled with wick, the one that i bought at the moment has only two small wicks with coils, basically the same size you'd put into an iClear 16 or 30. Is there a difference? Does more wick give more flavor and more vapes per drip?

 

[JBL-37]

It holds more juice between drips. A smaller chamber will produce better flavors though.