I have the xcube 2. On the rba I built a nickel coil and all it does is start for 3 seconds then say temp protected. I though ok, so I will build a stainless steel one, I built one and it came out to 0.15 Ohms, I saturated the wick and coil real well set my xcube to temp mode and stainless steel, fired it up and same thing starts up for a few seconds and goes to "temp protected" am I doing something wrong?
This is my first temp control device and I am thinking i must be doing something wrong but I really can't figure it out.
This is my first temp control device and I am thinking i must be doing something wrong but I really can't figure it out.