Glas mod?

[sacullen]

Ohms are the unit of measurement for resistance. They are not synonyms.

If someone asks how much you weigh, you'd probably look at them ....-eyed if they asked, "What are your pounds?"

 

[zoiDman]

Ohms are the unit of measurement for resistance. They are not synonyms.

If someone asks how much you weigh, you'd probably look at them ....-eyed if they asked, "What are your pounds?"

Just too Early in the Mourning to discuss Symantec's and their Use and Mis-Use in Modern Society.

And I'll say it again...

Be Careful using such Low Ohms.

 

[entropy1049]

Just too Early in the Mourning

Too early? How many minutes is it? BTW, my condolences.

 

[sig-cmt]

The word you are all looking for is resistance.

And I'll say it again...Be careful using such low ohms.

Sorry, but you are both wrong . The phrase you are all looking for is super sub ohmage as in: "What? 0.08? Yeah...Now that's some super sub ohmage...".

 

[Bad Ninja]

When I see "the phrase "my build ohms out at....", followed by a sub-.1 ohm resistance value I also see the "writing on the wall".

 

[EINTKALILFG]

...and what "writing on the wall" would that be? My guess is you're trying to suggest that I don't know what I'm doing, but you couldn't be further from the truth.

I know my builds, battery safety, and equipment top to bottom. I know what I'm doing, and if you're attempting to imply otherwise based on the colloquial nature of my terminology, try again.

 

[Bad Ninja]

...and what "writing on the wall" would that be? My guess is you're trying to suggest that I don't know what I'm doing, but you couldn't be further from the truth.

I know my builds, battery safety, and equipment top to bottom. I know what I'm doing, and if you're attempting to imply otherwise based on the colloquial nature of my terminology, try again.

It implies to me a lack of attention or concern with detail when expressing a technical description. I could be wrong, but if you understand the correct terminology, there must be a reason you decided not to use it.
Just sayin.

 

[Vaslovik]

Performance is where I found the biggest difference. On the two devices, I used (pretty consistently) a Tugboat v2 with a Pour Boy Customs comp cap. My go-to builds are either 20g Royal Wires, dual 5 wrap continuous on a 9/64 drill bit, which ohms out to around.08, give or take, and 22g Royal Wires, continuous dual parallel, 5 wraps on a 9/64 drill bit, which ohms out to around the same.08 or very slightly lower, with a faster ramp time.

That said, the Poldiac absolutely cannot handle those builds....

Good lord! I can't handle those builds! Why on earth would anyone want to do that? It's certainly NOT what I bought my Poldiacs for! That's really quite extreme stuff, and I'm compelled to say, hardly relevant to the thread.