Building on RBAs without screws... (and anyone know thread dimensions?)

[Slimer]

So due to unfortunate circumstances both my new VV Grand and my VV Woodvil are out of commission. This is due to a combination of bad luck (Being sent an ERA without screws in the terminals, being fixed by the vendor) and clumsiness (I lost one of the screws in my Reomizer 1 doing a rebuild this morning) and I'm rather unhappy using a Vamo and Bully knock off. I took a shot at building with no screws and it vapes, but does so incredibly harshly. So...

Does anyone have any tips for doing builds without screws? Pics would be super duper helpful

Also does anyone know the thread dimensions for the ERA or Reomizer 1? Links would be amazing

Any help would be greatly appreciated by my fiance as I'm being somewhat of a grumpy douche today

 

[darkzero]

Damn, that sucks, hope you get fixed up soon.

Hmm, mounting a coil without screws? ........... Make the coil leads long, insert into the post holes, hold in place, bend the exit end to the side, & wrap a few times around the post. Should stay in place well enough, especially with the lower/thicker guage wires.

 

[technicianx]

So due to unfortunate circumstances both my new VV Grand and my VV Woodvil are out of commission. This is due to a combination of bad luck (Being sent an ERA without screws in the terminals, being fixed by the vendor) and clumsiness (I lost one of the screws in my Reomizer 1 doing a rebuild this morning) and I'm rather unhappy using a Vamo and Bully knock off. I took a shot at building with no screws and it vapes, but does so incredibly harshly. So...

Does anyone have any tips for doing builds without screws? Pics would be super duper helpful

Also does anyone know the thread dimensions for the ERA or Reomizer 1? Links would be amazing

Any help would be greatly appreciated by my fiance as I'm being somewhat of a grumpy douche today

Do you have a hardware store? You may find them there. Or maybe a hobby store. You could see if the screws in a eye glasses repair kit fit?**that just dawned on me that a glasses screws are tiny like rebuildables** If you got the time those may be worth a shot?

Sent from my SGH-S959G using Tapatalk 2

 

[Needo]

A toothpick might be a quick and dirty fix. Use it to press the wire of the coil against the inside of the post. This should work until you find screws that fit.