New member, 1st post.
I've learned good information from this forum- Thanks.
Thought this photo might help someone .
Need to look at the attached photo, or the following will sound like gibberish.
I used a 3/32" drill bit to enlarge existing aspire coil holes.
Maybe easier to start off with a smaller drill and work up to 3/32".
fastech prewound coil with non resistive (nr) legs.
Coil inserted from bottom. Toothpick through holes and coil. Bend over legs to stabilize coil.
Tread cotton wick through new coil.
I've learned good information from this forum- Thanks.
Thought this photo might help someone .
Need to look at the attached photo, or the following will sound like gibberish.
I used a 3/32" drill bit to enlarge existing aspire coil holes.
Maybe easier to start off with a smaller drill and work up to 3/32".
fastech prewound coil with non resistive (nr) legs.
Coil inserted from bottom. Toothpick through holes and coil. Bend over legs to stabilize coil.
Tread cotton wick through new coil.
Attachments
Last edited:
