Hey guys,
I have decided to build my own coils. I dabbled previously but costs of premades are just ridiculous. I have chosen the Hellvape Fat Rabbit Dual coil build system with the 5.5ml tank based on reviews etc. I am an MTL vaper and over the past few weeks have discovered I like 0.6 - 0.8 ohm premade coils. I would like to take that as a starting point before trying to go lower.
I am just a little confused with heat capacity on Coil wrapping | Steam Engine | free vaping calculators - I need to choose the kanthal wire and am confused as to which to buy.
Should I be aiming for slow to heat & slow to cool down (24awg) 32w or quick to heat & quick to slow down (26awg) 18w?
Which diameter of coil should I start with? My kit starts at 1.5mm and goes to 4mm
As always, any advice is greatly appreciated.
I have decided to build my own coils. I dabbled previously but costs of premades are just ridiculous. I have chosen the Hellvape Fat Rabbit Dual coil build system with the 5.5ml tank based on reviews etc. I am an MTL vaper and over the past few weeks have discovered I like 0.6 - 0.8 ohm premade coils. I would like to take that as a starting point before trying to go lower.
I am just a little confused with heat capacity on Coil wrapping | Steam Engine | free vaping calculators - I need to choose the kanthal wire and am confused as to which to buy.
Should I be aiming for slow to heat & slow to cool down (24awg) 32w or quick to heat & quick to slow down (26awg) 18w?
Which diameter of coil should I start with? My kit starts at 1.5mm and goes to 4mm
As always, any advice is greatly appreciated.