The Coolest IPro

Status
Not open for further replies.

FreeFire

Super Member
ECF Veteran
Jan 8, 2012
861
1,255
67
Twin Cities Minnesota
Hehe....ok, you wanted a pic....only did one as all my creative software is at home on the Mac :)

i-n4CN7Cj-XL.jpg
 

FreeFire

Super Member
ECF Veteran
Jan 8, 2012
861
1,255
67
Twin Cities Minnesota
That's a Smoketech with a dcc pre-punched carto...I think it's the 3.5 mil version if I remember correctly. I like the tank and the way it fills, just not overly excited about having to purchase 1.5 ohm dcc's to fit it as the cartos have a "flange" on the bottom. I took a 5 mil Smoketech (as the carto burnt right away) and cut it down so a standard size carto would fit. Next, I'm going to the drill press and drill the proper size hole after running to the hardware store to find a good plastic thumbscrew. (would order one from Notcigs but most likely will just buy a couple more M1A1 tanks and be done with it...).

The tanks are nice....I like them, no leaking, nice looking....just stuck with that dcc carto thingy...IKenvape has a larger one to buy when in stock I may try but it still should have something to keep the carto from sliding up and down.
 
Status
Not open for further replies.

Users who are viewing this thread