Courtesy of James1628:
Just moving this over from the other thread:
I thought I would post up some pics of my setup and a video of the performance. I will put this in the build thread if it reopens.
The setup is a single coil of 30awg kanthal, 6 wraps, on a nail that is somewhere between 1/16 and 5/64. I use the nail because it fits perfectly in my Squape wick channel, whereas 5/64 is slightly too big. Anywho, I don't have a good ohm meter to use on the Strata due to the hybrid connector, but this setup always comes out right at 1.5 ohms.
The coil is placed as far out as possible, right up against the outer wall (without touching). I also curve the coil slightly outward to run right along the outer wall (again, without touching). I bent it outward with a flathead screwdriver, very easy to do. I only bent it after installing the cotton. The setup results in some long coil tails to the posts. I draped some cotton over them to eliminate hot legs. The empty side of the atty has Spheroid filler in it to prevent flooding.
I marked the base with a sharpie to identify the location of the center of the coil. I also marked the cap to identify airhole location. Note that I don't have the airhole directly in front of the coil, but basically at one end of the coil.
In this configuration, it works well and the setup is relatively easy. I did post a video of the vapor I'm getting from it. It's pretty much on par with my other attys. In the video, I'm using a P+18350. Pics speak for themselves I think.
Video of performance:
IMG 0883[1] on Vimeo