Need help battery/Mech Mod safety advice

[o0ohydr0o0o]

Using a sigelei Chi you 18350 clone, with Efest IMR 3.7v battery. Looking for some info on battery mech mod safety for my particular battery I am using. I am not Sub Ohm vaping with this, i'm sticking around 1.1 or 1.2 ohms. Can any one help a noob re-builder out?
Thanks in Advance!


o0ohydr0o0o

 

[steved5600]

OK 1.1 and 1.2 is not sub ohm. assuming a fresh battery at 4.2 volts 1.1 ohms will give you 16 watts and 1.2 a bit over 14 watts and at 1.1 ohm your only pulling a bit under 4 amps. FYI if your a rebuilder you got to learn ohms laws, use an ohm meter and practice battery safety. Never exceed the limit of a battery, don't let it discharge below 3.4 volts, use a good smart charger so you can't overcharge a battery. Never use a battery that has vented. Don't buy any battery with the word Fire in it. USE what ever locking system your mech has. I'm attaching a spread sheet that will do voltage, wattage and ohms calculations for single and dual coils. Also a pic that shows ohms laws at work. View attachment wattscalcdhartv1A.xlsx
here is a web site that will do wire calculations for you as well as volt,ohm calcs. Coil wrapping | Steam Engine | free vaping calculators