Innokin Z Coil Vg/pg ratio

[Alex Mohler]

I just got a Zenith 2 tank, and I'm using the 1.2 ohm coils. And I put a 70vg/30pg in and I'm getting dry/burnt hits, and running it at 12.5 watts. Does anyone have any suggestions as to why this is happening, or what I should do?

 

[TP49]

I just got a Zenith 2 tank, and I'm using the 1.2 ohm coils. And I put a 70vg/30pg in and I'm getting dry/burnt hits, and running it at 12.5 watts. Does anyone have any suggestions as to why this is happening, or what I should do?

If I had that tank and the 1.2 ohm coil I would use 50/50 eliquid in it, Innokin Zenith tanks are rated highly. I have the Zlide tanks with no problems using the above.

 

[Letitia]

I just got a Zenith 2 tank, and I'm using the 1.2 ohm coils. And I put a 70vg/30pg in and I'm getting dry/burnt hits, and running it at 12.5 watts. Does anyone have any suggestions as to why this is happening, or what I should do?

If you're chain vaping the wick probably isn't being given enough time to saturate between hits. Try adding a couple drops of distilled water to the tank at a time, shouldn't need more than few drops. The water must be distilled and not water from the tap. Could also try a coil with more af.

 

[Alex Mohler]

If I had that tank and the 1.2 ohm coil I would use 50/50 eliquid in it, Innokin Zenith tanks are rated highly. I have the Zlide tanks with no problems using the above.

I did try a 50/50 nic salt and it happened a couple times

 

[TP49]

I don’t use nic salts so I don’t know much about them I use freebase 50/50 eliquid. I’m assuming you’re priming the coils properly and letting the coil soak for 10 minutes before you start using your device.