I figured this would be the best place to put this question since it's subject concerns some issues that folks may run into here while making or modifying a tank.
On to the question, I have a first generation Kanger Protank where the body, glass bit, is glued to the bottom metal piece that screws into the Skirted piece of an eGo battery adaptor. One friend was using the glass piece to screw the Protank onto and off of her mod and to refill the ejuice. Short story shorter she popped the glass piece of the first gen Protank.
Big question part, what type of adhesive should I use to "GLUE" the Glass to the bottom metal Piece. Something that is non toxic and will survive the repeated stresses of day to day use that a Protank would encounter?
On to the question, I have a first generation Kanger Protank where the body, glass bit, is glued to the bottom metal piece that screws into the Skirted piece of an eGo battery adaptor. One friend was using the glass piece to screw the Protank onto and off of her mod and to refill the ejuice. Short story shorter she popped the glass piece of the first gen Protank.
Big question part, what type of adhesive should I use to "GLUE" the Glass to the bottom metal Piece. Something that is non toxic and will survive the repeated stresses of day to day use that a Protank would encounter?