I am new to rebuilding atty coils and wicks,
Here goes,
I have the following multi meter (see photo below)
Where do I plug the black and read probe connectors into the meter?
What ohms setting do I need to set meter too?
When I have fitted my ss mesh wick (which I have oxidized) and put my coil turns around the wick(4 turns 0.20 kanthal wire) where do I test with my meter probe ends to test the ohms on the coil?
I am building wick/coils for my nova v2 hybrid
18mg ry4 70/30 pg/vg
Thanks
Karl.
Here goes,
I have the following multi meter (see photo below)
Where do I plug the black and read probe connectors into the meter?
What ohms setting do I need to set meter too?
When I have fitted my ss mesh wick (which I have oxidized) and put my coil turns around the wick(4 turns 0.20 kanthal wire) where do I test with my meter probe ends to test the ohms on the coil?
I am building wick/coils for my nova v2 hybrid
18mg ry4 70/30 pg/vg
Thanks
Karl.