Hello everyone, I am new to this forum and fairly new to vaping as well, been vaping for about a month now. I just bought a Unitank by Kanger today from a local smoke shop and I love it, great taste and vapor. Only problem is the drip tip is a bit loose. It wiggles around instead of sitting firmly on top. Anybody else have this problem with Unitanks? Or anyone have any suggestions on what to do to fix this? Doesn't seem to be a problem as far as vaping, just annoying hearing it rattle. Thanks in advanced.
Unitank Drip Tip Problem
- Thread starter jimmy0403
- Start date
- th_trl_thread_readers 0
- Status
Hi Jimmy... welcome to ECF
Visit your local B&M, and see if they have any alternate, as in thicker, drip tip o-rings. They come in a variety of sizes.
Visit your local B&M, and see if they have any alternate, as in thicker, drip tip o-rings. They come in a variety of sizes.
The best way to fix that issue I find, is take your o-ring off DT wrap a small piece of dental floss ware o-ring goes then put o-ring back on works like a charm!
I have had this problem in the past (not on this tank but on a multitude of others) and would have never thought of that! I usually just end up buying random tips until I find one that fits. Thank you!
this kind of depends on the drip tip as well. if its just small in general and you get a bigger oring or use the dental floss technique it will still feel loose. hopefully your b&m will know which drip tips are larger in size. a lot of my aluminum drip tips from random places seem to be bigger in size and fit more snugly in everything or in not at all in some cases.
I don't know if it happens with other brands too but with my two iclear30s tanks i had the same issue.
With one i saw it on time and the other was leaking.
When they assemble the coilheads-atomizers these tanks are dry and the rubber sealing gets pushed out or twisted and make these things leak.
That was the case with both my iclear30s. After i removed the atomizers and put the rings back in place all was fine. Now the atomizers slip in without a problem because the fluid lubricate the rubber seals.
With new tanks check before use that everything sits in place like it should.
With one i saw it on time and the other was leaking.
When they assemble the coilheads-atomizers these tanks are dry and the rubber sealing gets pushed out or twisted and make these things leak.
That was the case with both my iclear30s. After i removed the atomizers and put the rings back in place all was fine. Now the atomizers slip in without a problem because the fluid lubricate the rubber seals.
With new tanks check before use that everything sits in place like it should.
Thanks for the advice everyone. I'll try the dental floss trick first, if not, I'll visit my local shop for different o rings. It shouldn't be a problem with the drip tip itself though, it's the one it comes with. Thanks again.
- Status
Similar threads
