Hi guys,
I started vaping about a month ago on an iTaste VV V3 + Kangertank Protank 3. Within 2 weeks and was ready for an upgrade. I bought the GP Paps Clone by Vapetech (running in 18350 mode on the Efest 3.7V 800mAh battery) + Terminator-C RBA, simply because I wanted to try it out before I buy the real thing.
The coil and wick were set up in store all ready for me to vape on. The guy at the store advised me to use a 1 ohm ready-made coil (which after connecting it onto the iTaste shows me a 1.1 / 1.2 ohm reading). After a couple of hours I was getting burnt taste, gurgling and flooding issues. I've gone through 4 coils within 5 days, a few different wicks, almost 1 and a half bottles of juice and a full roll of tissue!
There is an airflow control on the Terminator (by twisting the centre post that works as the tip), that helps with the burning taste for a bit but then the flooding is back. I can't go more than 10-15 vapes without it flooding or gurgling. Since the rba doesn't sit flush on the paps, the juice is also flooding straight through the 510 connection into the pin section.
On my iTaste V3 + Protank, I have a 2 ohm coil running and I set my wattage on 8W for my sweet vaping. But on this, I am running it at around 11.4W (3.7V battery on a 1.2 ohm coil) - Is that reasonable?
Anyone able to advise me would be much appreciated!
I started vaping about a month ago on an iTaste VV V3 + Kangertank Protank 3. Within 2 weeks and was ready for an upgrade. I bought the GP Paps Clone by Vapetech (running in 18350 mode on the Efest 3.7V 800mAh battery) + Terminator-C RBA, simply because I wanted to try it out before I buy the real thing.
The coil and wick were set up in store all ready for me to vape on. The guy at the store advised me to use a 1 ohm ready-made coil (which after connecting it onto the iTaste shows me a 1.1 / 1.2 ohm reading). After a couple of hours I was getting burnt taste, gurgling and flooding issues. I've gone through 4 coils within 5 days, a few different wicks, almost 1 and a half bottles of juice and a full roll of tissue!
There is an airflow control on the Terminator (by twisting the centre post that works as the tip), that helps with the burning taste for a bit but then the flooding is back. I can't go more than 10-15 vapes without it flooding or gurgling. Since the rba doesn't sit flush on the paps, the juice is also flooding straight through the 510 connection into the pin section.
On my iTaste V3 + Protank, I have a 2 ohm coil running and I set my wattage on 8W for my sweet vaping. But on this, I am running it at around 11.4W (3.7V battery on a 1.2 ohm coil) - Is that reasonable?
Anyone able to advise me would be much appreciated!
Last edited:
