RDA Temp Control on the Marquis RDA with Titanium

[Cbauer210]

Just thought I'd show off my latest build a little. I just got into rda's a few weeks ago and am really enjoying them over the tanks.

Its a Marquis RDA with dual coils...7.5 wraps each of 26 gauge titanium. It's clocking in at .16 ohms on the IPV D2. This is my first temp control build & i'm really loving it at 40 joules and 400 deg. How's she looking? Anything I need to be careful of as I move forward with this besides not dry burning the titanium?

 

[RipCigs]

Aren't temp control builds supposed to be 0.1-0.4 ohms to work properly? I'm honestly asking, not telling

 

[inswva]

Aren't temp control builds supposed to be 0.1-0.4 ohms to work properly? I'm honestly asking, not telling

I believe the OP misplaced the decimal. It's likely a 0.16 build. A 1.6 build would require like 80 wraps per coil.

 

[kkiet]

Not Bad

 

[Cbauer210]

You are correct...it is .16 ohms. My bad.

 

[SpartanM]

is titanium wire supposed to get better flavor compared to nickel? I recently switched from a parallel dual 24g 5 contact wrap at 0.12 on my mxv4 on an ipv3 with kanthal to a dual 28g nickel 9 wrap spaced build for the TC, buts it's been pretty lacking in terms of ramp up time and flavor... unless I close off all side airflow :\

just curious is titanium is worth it to get, if I was looking for decent flavor but mostly looking for clouds?


-themaxster