Special Purchase Panasonic Hybrid/IMR 18650 Lots of 10

[forcedfuel50]

Lot of 10 Blemished Panasonic CGR18650CH Hybrid/IMR 18650 2250mAh Flat Top.

These are for lots of ten batteries. All have a small indents/tears where it appears the machine crimped on the top connector and tore the protective covering(see picture).

All are 100% brand new, unused and 100% functioning, but you will need to cover the to torn area near the top of each battery.

All lots are sold as is, no returns, no refunds.

To order, visit: Super T Manufacturing, Innovative manufacturer of electronic cigarette products.

 

[Technonut]

Sweet Deal.... Many of my AW IMR 1600mAh 18650's are close to 2 years old. In fact, I had 2 go bad in the past few weeks.

The timing is great for these.... I'm in for 10....

 

[snork]

Can somebody tell me whether they fit/work in a P+ and whether they're Kick approved?

 

[forcedfuel50]

Yes and Yes Snork.

 

[snork]

Excellent. Got some.
I might have accidentally put a ShockWave or two in my cart also, could you take care of that for me?

Just kidding.

 

[forcedfuel50]

Still have a couple of lots left!

 

[forcedfuel50]

We still have some lots left!

 

[snork]

Sweet Deal.... Many of my AW IMR 1600mAh 18650's are close to 2 years old. In fact, I had 2 go bad in the past few weeks.

The timing is great for these.... I'm in for 10....

I was kind of in the same boat as you, some of my AWs were bought last May 2011, the most recent were from December 2011. I've been limping along, beeyatching about how my Kick didn't like 'em, etc. This was an excellent deal! One layer of electrical tape (only one, no room for more) and good as new! I'm really liking them!

And BTW, in case anybody's wondering, these flat-tops used the exact same o-ring and washer set up in my P+ as the AW IMR 1600s.

 

[Technonut]

I was kind of in the same boat as you, some of my AWs were bought last May 2011, the most recent were from December 2011. I've been limping along, beeyatching about how my Kick didn't like 'em, etc. This was an excellent deal! One layer of electrical tape (only one, no room for more) and good as new! I'm really liking them!

And BTW, in case anybody's wondering, these flat-tops used the exact same o-ring and washer set up in my P+ as the AW IMR 1600s.

My batts arrived yesterday... They are performing VERY well. I'm currently using them in a dual 18650 VV mod, and I now see a notable difference in run time compared to my old AW IMRs.

I checked the small tears in the casing with my multimeter, and there is no current running through. I just placed a thin layer of silicone around the tears for piss & giggles.