Guys, some things for 510 adapter:
Those cheap adapters would work better if we eliminate by sanding the 4 cuts that are in their perimeter, so we have to sand the adapter about 0,5-1mm. If its total length is 10mm it has to go to 9mm. Also those adapters have to have a hole through their pin. But I see that some friends here have good results even if they dont sand it.
If those adapters are 10mm in length then the breathing holes of the 510 atomizer would be around 5mm higher than the 901. AFS is about 25mm in length so if we loose 5mm we lose 1/5 of the liquid use. Its not a very big amount of liquid loss if you want a cheap and easy solution.
The bad thing is that maybe those adapters will not fit on the brass connector of AFS because I made threads for SLB 901 and they are a very little different than the others. But as Jumi said you can try to sand a little the threads so they can fit to the adapter. If you dont want to mess with the AFS brass connector you can sand the cheap adapter's threads so they can fit in the AFS brass connector
Conclution: The only you need is a little sanding on the threads of brass connector of AFS, so they will be a little shorter, or better to sand the threads of the adapter. When you do it then try to vape. If you see that atomizer is not feeded properly then sand the adapter as I said, so breathing holes of the 510 will be exposed
ps...... when I say to sand the threads of AFS or adapter's threads I dont mean to make the total length of the adapter shorter, I mean to make the threads shorter. You can do that by putting a sandpaper inside the adapter and start moving it around the threads.
Those cheap adapters would work better if we eliminate by sanding the 4 cuts that are in their perimeter, so we have to sand the adapter about 0,5-1mm. If its total length is 10mm it has to go to 9mm. Also those adapters have to have a hole through their pin. But I see that some friends here have good results even if they dont sand it.
If those adapters are 10mm in length then the breathing holes of the 510 atomizer would be around 5mm higher than the 901. AFS is about 25mm in length so if we loose 5mm we lose 1/5 of the liquid use. Its not a very big amount of liquid loss if you want a cheap and easy solution.
The bad thing is that maybe those adapters will not fit on the brass connector of AFS because I made threads for SLB 901 and they are a very little different than the others. But as Jumi said you can try to sand a little the threads so they can fit to the adapter. If you dont want to mess with the AFS brass connector you can sand the cheap adapter's threads so they can fit in the AFS brass connector
Conclution: The only you need is a little sanding on the threads of brass connector of AFS, so they will be a little shorter, or better to sand the threads of the adapter. When you do it then try to vape. If you see that atomizer is not feeded properly then sand the adapter as I said, so breathing holes of the 510 will be exposed
ps...... when I say to sand the threads of AFS or adapter's threads I dont mean to make the total length of the adapter shorter, I mean to make the threads shorter. You can do that by putting a sandpaper inside the adapter and start moving it around the threads.
Last edited:
