Rx200 reading voltage

[meemo]

hi guys so I own a restaurant and just got my rx200 n 6 lg hg2 batteries a week ago. Was buzy so finally got to charging the batteries in my nitecore i4. Waited for them to charge fully. Now when I check the voltage of the three batteries on my rx200 they read at 4.23,4.32and 4.26. I have a griffin tank with the coils reading at 0.42 ohms. Is it safe to vape with such a different in the batteries voltage?? Thanks

 

[IrkMe]

Yes it will be safe to vape, I've found the RX200 isn't very accurate at reading voltage on a freshly charged set of batteries. Once your voltage drops on them it seems to settle out to within 0.1 difference.

If you want to be extra cautious, check your battery voltage on a multi meter or if your nitecore has a voltage display (I use a D4 which does) check it on that.

 

[Georgie-1-Lung]

^agree - they will level out, and the RX is definitely not accurate at reading V. -

 

[suprtrkr]

+1. The RX has no idea what voltage its batteries are, but it uses them very evenly. I have seen the mod shoeing jearly half a volt difference, but take them out and measure them, they're usually within .02V.

 

[BrotherBob]

Welcome and glad you joined.
Might like to read:
What is Sub Ohm Vaping? Our Sub Ohm Vaping Guide & Tips
ECF Sub-Ohm Advisory
18650 Battery Buying Guide for Vapor Users
15 things every LiPo battery user should know

 

[meemo]

Thanks for the reply guys. Been busy and too excited to start I left the Rex for a couple of hours and went out when I came back two of the batteries were within each other but the one showing 4.32 came down to about 4.28. Just waiting on my juice to get to me so I can start. Also have to check the firmware on my Rex cuz while levelling out the hotspots I'm my coil I noticed the front end where the display is was getting warm pretty quick. Don't know what firmware it is but will update it once I get up in the morning. Hopefully that will solve the problem. Thanks for the warm welcome to the forums. You guys n gals are very helpful to a new vapor like me. Cheers and Vape onnnnnn

 

[meemo]

+1. The RX has no idea what voltage its batteries are, but it uses them very evenly. I have seen the mod shoeing jearly half a volt difference, but take them out and measure them, they're usually within .02V.

Thanks for the reply guys. Been busy and too excited to start I left the Rex for a couple of hours and went out when I came back two of the batteries were within each other but the one showing 4.32 came down to about 4.28. Just waiting on my juice to get to me so I can start. Also have to check the firmware on my Rex cuz while levelling out the hotspots I'm my coil I noticed the front end where the display is was getting warm pretty quick. Don't know what firmware it is but will update it once I get up in the morning. Hopefully that will solve the problem. Thanks for the warm welcome to the forums. You guys n gals are very helpful to a new vapor like me. Cheers and Vape onnnnnn