question re ohms and kanger sub tank

Status
Not open for further replies.

Caro123

Super Member
Apr 11, 2015
810
1,188
Nova Scotia
hello all I have a question: just bought a kanger sub tank mini put it on my istick 50 it reads 0.7 ohms, put it on my 20 watt istick it reads 0.6 ohms put it on my ohm reader it reads 0.61 ohms. Engraved on the side of the coil it says 0.5 ohms is this likely just a glitch in the 50 reading it higher or the probability of an extra wrap on the coil head and what if any difference what so ever would it make ?

I am not terribly sure of the ohm, watt, info. The biggest reason I haven't bought something like a mech mod or anything unregulated

thanks for any info you might give
Carolyn
 

Rixsta

The Millionaire Vapor' The Enabler
ECF Veteran
Verified Member
Apr 8, 2015
6,590
39,922
49
Somerset, UK
Pretty normal for Isticks, out of all the 0.5 kanger coils I used on my Isticks, only a few read 0.5. You may find that unscrewing the tank off the Istick and back on again, a little tighter, you can change the reading, I have had some read 0.9, trouble is, that changes the voltage and would cause dry hits sometimes. I would usually, try the above or take the coil out the base, screw it back in again 99% of the time I could get it to read 0.6ohms

r94dps.jpg
 
Last edited:
  • Like
Reactions: Caro123
Status
Not open for further replies.

Users who are viewing this thread