I bought a kylin m to go into my stubby aio. I did no research my fault of course. As I was building it. I realized how it go juice. I said there's no way that's not going to flood, but Mike vapes built one it didn't flood. So against my better judgement I built and put juice in and it all ran out the air flow. How are u supposed to keep it from flooding? The juices just pours through holes onto the cottone what keeps it all from coming through there I don't understand. Any help is greatly appreciated. I'm already very frustrated by this boros
Kylin M boro tank?
- Thread starter cambford91
- Start date
- th_trl_thread_readers 0
Well better late then never........ Got myself one of these and yes i know this is over 1 year old!!!
Coming from 80% mesh use this shouldn't be too hard to build: WRONG!
Normally i wick mesh all the same: take 2mm of the lace, put it through the mesh, trim it up and soak the s*** out of it, no dry hits please. This one, not so much. First try: cut the tails to the rim of the cap, trimmed it out and soaked it, put the cap on, placed in boro tank, boro tank in mod and .......... no flavour at all. After a short while i had all 3 ml in my mod and over my desk. Clean-up time.
Cotton out, new cotton in and this time i left some more cotton on the sidesbut still trimmed the top off. No more leaks, good vapor and a good flavour.
Conclusion: just enough cotton to "dam" the sides, not too high and you're set. This a good tank for those, like me, still use mesh for now the only downside is the too low capacity of it, i know "space" is limited in boro tanks but 3ml for a mesh tank just isn't enough.
Rocking this on a Tycoon with SS mesh in temp. control and loving it.
Beco
Coming from 80% mesh use this shouldn't be too hard to build: WRONG!
Normally i wick mesh all the same: take 2mm of the lace, put it through the mesh, trim it up and soak the s*** out of it, no dry hits please. This one, not so much. First try: cut the tails to the rim of the cap, trimmed it out and soaked it, put the cap on, placed in boro tank, boro tank in mod and .......... no flavour at all. After a short while i had all 3 ml in my mod and over my desk. Clean-up time.
Cotton out, new cotton in and this time i left some more cotton on the sidesbut still trimmed the top off. No more leaks, good vapor and a good flavour.
Conclusion: just enough cotton to "dam" the sides, not too high and you're set. This a good tank for those, like me, still use mesh for now the only downside is the too low capacity of it, i know "space" is limited in boro tanks but 3ml for a mesh tank just isn't enough.
Rocking this on a Tycoon with SS mesh in temp. control and loving it.
Beco
Similar threads
- Locked
