Kaiser Atomizer

[Clmarti78]

Lots of post here going to back track now but any new post on the issue I'm having is greatly appreciated thanks.

 

[350ZMO]

I bought this for my cousin and the first build was a pain in the %!$@ but after that not bad. He like the 2 ohm range so I used 30 gauge with 19 wraps on the second to smallest post that came on a jig I bought. Sorry I don't know the size. So two coils with 19 wraps place one in place with the ceramic bowl in place as well then just put the second one next to it. Tightened both post down gave all contacts a little tug to make sure they were set then just adjusted cois to where they look nice and even. Did some cotton wick and it was good to go. The only thing he is having an Issue whith now is it leaks out of the air in take holes. I tried to out more wick to stop as much juice flow and it works for a week but then he starts getting leaks again. We start the juice control chimney snug and then back it of not even a 1/4 turn just enough to get good flavor and not to get dry burns. Any ideas on how to stop the leak? Other than that it seems to he a great tank for a newbie at Eva's.... As long as you have a cousin that like to build at least. But any tips would be great thanks guys.

I have two Kaisers one is constantly giving dry hits the other is perfect. Of course I'm using ceramic donuts and rayon. Two things to try. You can add a layer on top of the coils that are there going through the juice slots kind of like a flavor wick some call it. You can also lay a bed of wicking in the cup then put in the coils, put a toothpick or small screwdriver in the air hole when doing this. Ahh the art of wicking...currently trying to wick a fogger V5 perfectly. Too much and you'll get dry hits too little and it'll leak. It can be a real pain on any atty. Getting the right amount of wicking in all the juice slots can take some trial and error.