I Don't Like My Genuine Kangertech MT3S Bottom Coil Clearomizer

[mmorris]

Hello,
I quit smoking cigarettes over 6 weeks now and I purchased 4 Genuine Kanger tech MT3S Bottom Coil Clearomizers plus 4 extra coils. I don't really like them compared to my starter kit plastic clearomizers. I have been trying to like them for over 2 weeks but the draw on them seem so weak. Is there anything I can do to make them seem less airy? ty

 

[H Niemand]

If you look on the bottom, there are 2 tiny holes. Try covering one as you draw. It will reduce the air mix. Be careful not to draw too hard. It will flood.

 

[Enoch777]

Not sure what known methods there are, I'm slightly unfamiliar with the MT3s but I have seen a review and some pictures. That being said, some people plug up some of the airholes on the Protank for a stiffer draw. Might work for the MT3s as well. I believe they were using toothpicks or some such and breaking them off inside.

Alright, admittedly that method is a bit crass and reserved for a somewhat desperate scenario.

I do know however that you can get a 510 tank airflow controller so you can adjust the draw no matter what device you're using. Cheers

 

[gingersnaps]

I like a tight draw so i use a drop of clear polish to cover a hole. Covering 2 gives a very tight draw like a thick milkshake so i do only one.

I like the polish bc its discreet and. An easily be punched through if I change my mind

Sent from my iPhone using Tapatalk - now Free

 

[Phone Guy]

Why not use a small piece of tape? Simple, reversible and discreet.

 

[gingersnaps]

I used to use tape but it always fell off or peeled. Besides a qtip and a dab of acetone removes it completely. I normally just pop a paper clip through then remove it all when I clean the tank if i want more flow.


Sent from my iPhone using Tapatalk - now Free

 

[crxess]

I push a toothpick into 1 hole and snap it off. After a bit of handling it no longer shows.
You can also place a piece of tape, a spot of super glue, anything basically that will fill side hole.

Fill 2 holes and it will get VERY tight
Fill all 3 and Bust a lung

T3 can provide a very good Vape, has nice capacity and needs service 1/2 as often as my Evods. YMMV

 

[mmorris]

Thank you for all your suggestions... I don't want to "bust a lung" so I will try covering one hole

 

[Ladiekali]

Try loosening it, dont screw it on too tight i line a hole up with the battery button and it makes a world of differnce, just figured it out!