How to Get Water Out of My Vape?

[Eightvapejasmine]

A customer recently asked me how to get water out of their vape. Here’s what I suggested:

1. Disassemble the Vape: Take apart the tank, coil, and battery. Make sure to remove any detachable parts to allow thorough drying.
2. Shake Out Excess Water: Gently shake the device to remove any excess water trapped inside.
3. Dry with a Towel: Use a soft, dry towel to wipe down all parts, paying special attention to the tank and battery connections.
4. Use Compressed Air: If available, use a can of compressed air to blow out any remaining water, especially from small crevices.
5. Air Dry: Leave all the parts out to air dry completely for at least 24 hours. Ensure they are in a well-ventilated area.
6. Check for Residue: Before reassembling, check for any water residue or damage. Make sure everything is completely dry to prevent short circuits.
7. Test Before Use: Once everything is dry, reassemble your vape and test it to ensure it’s working properly.

What do you all think? Any other tips or methods for getting water out of a vape?

 

[Bingbong]

Disassemble and put into a container of dried rice. The rice will pull out moisture. Works for any type of electronic device that gets wet.

 

[Eightvapejasmine]

Disassemble and put into a container of dried rice. The rice will pull out moisture. Works for any type of electronic device that gets wet.

Thank you for the suggestion! Using dried rice to absorb moisture is a great tip and can be very effective for electronic devices. I'll definitely consider adding it to my list. Thanks again!