Hot spots on coil
- Thread starter suppavillin
- Start date
- th_trl_thread_readers 0
- Status
Do any of you guys have a spheroid? I wish I could see someones build. And use the same exact wire as they are.
Yea, it would fit if not folded over. I got it thorugh but of course now the coil isn't burning correctly,lol. Being new sucks. I know its me so I am not that frustrated, its not the spheroid. I had it buring evenly but at that point I had incredible burned tast. So I could be having multiple issue, wicking issues and coil issues. Hopefully I can get this tomorrow, I have a few more hours to work on it tonight but I am down to my last piece of wire that they gave me....horrible wire at that. they put it around card board so there are kinks every where, every inch there is a kink.
when i get a new atomizer i usually disreguard the wire they include and just use stuff off the spool i got on amazon from temco i paid like 12 ish dollars for like 100 feet i use 28 usually unless im building a dripper for my 100 watt and ill use 24 for that and build subohm ive found 28 to be a good wire for most builds and 1.5-1.0 ohms for most of my builds sorry i couldnt help out more and good luck man
https://www.youtube.com/watch?v=QsQT14SEg2Q
just started watching a review for it by grimmgreen and he refers his viewers to this guy for the build tutorial side of it hope this gives you an idea just a tip with a higher number gauge wire less wraps are needed to get the target ohms that with a lower number gauge wire
just started watching a review for it by grimmgreen and he refers his viewers to this guy for the build tutorial side of it hope this gives you an idea just a tip with a higher number gauge wire less wraps are needed to get the target ohms that with a lower number gauge wire
It really just takes practice. The more you practice wrapping coils the better you're going to get at it.
I found it by searching for best sub 18mm atty. Seems this spheroid is one of the best addys out there, I just need to get the hang of this.
Man...his review really makes me want to get this thing going,lol. He has tried a Bitc* Ton of atomizers and he seems to like this one more than most. Ashame all I am getting from it is savory burnt wick flavor lol, had to check my e liquid and make sure I didn't by Savory burnt silica flavor. lol, sucks, Ill be back at it when my wire gets here, should be here tomorrow but I usually get things 1 day after expected delivery.
The spheroid is 16mm so I went with 30 guage wire because I do not have much room, hoping that 30 g is ok.
Now I am having another problem. I got a OHM meter from lightening vapes. I put my build on it and I got 1.4 ohms. I than stick it on my mod and my mod says its 0.4 ohms? I know im knew....but something wrong with one of the pieces of equipment here no? My mod works fine on any other atty. And this ohm meter is brand new. I am getting bummed and losing my drive now. I have been at this for quit a while now.
maybe when you are screwing it onto youe battery it is shorting a little bit maybe try and see the resistance when it barely makes connection or look at the center pin of the atty to see it it is off center and adjust it if needed
I got the coil part down. Thanks for the help guys. Now this thing is wicking like shiz,lol. On thing after the next. Ill figure it out. Thanks again all. 
- Status
Similar threads
