Hades 26650 and Cerberus tri coil dripper (Footoon)

[GrandFogger]

Set up my new Footoon Cerberus with 3-26g Kanthol 7 wrap coils. Using cotton cause i didn't want to waste the ekowool if it turned out to be a failure. Happy to say it turned out to be a home run. Getting .3ohms and all three fire to almost perfection (always room to improve). the Cerberus clone i have would fire dual coils well but tri coils, not so much. could have been the coil builder . Will let you know when i rebuild the clone. Going to rebuild the original with ekowool next week so i hope to get close to the sub ohms i have now.
Happy vaping!

 

[Susan~S]

Congratulations!

Make sure you have a safe battery (at least 30A continuous), from a reliable supplier if you are going to build low sub ohm.

 

[therussellv]

Got mine today, running .4 ohms, awesome.

 

[TwistedThrottle]

I also have the same setup. Lovin the hybrid mode! I did mine with twisted 28ga with 10 wraps and got .33 ohm. Taste, flavor- it's all there! How do you do dual coils on the Cerberus? Just leave a slot empty or turn the positive some way I don't know about?

 

[rbanks1667]

Been using twisted kanthal for some time, and have been wondering what size wraps you use. I try to watch the youtube vids, but 30 min to build an atty. Drives me nuts.

Thanks in advance

 

[TwistedThrottle]

I've got a small screwdriver that I twisted them on. It was the smallest one in the set and I think it's like 1.5mm. Worked well but tough to thread the cotton thru. Had to push it thru with another bit of twisted wire. Left the legs long and dropped a cotton cloud below and tucked the legs of cotton into that. Hope that helps!