Mine arrived and I built it with dual coils. Geekvape Ni80 Fused Clapton 28ga*3+40ga, 3mm i.d. 6 wraps ohmed out to .20 ohms with coil legs cut to 6mm. Very easy to build. As simple as 1, 2, 3. I haven’t tried it single coil yet but I will & will report back.
I love the etched leaves design, nice quality, o ring tolerances are perfect. I hate when the o rings are so tight I can’t pull off the top cap.
Comes with 2 ultem drips. 1 shorter & 1 wider, the other with the Geekvape name laser engraved, its taller & slighter smaller inner diameter. I tried both & I prefer the taller one as its not as airy.
ATTACH=full]767745[/ATTACH]
The airflow is really smooth & quiet. I prefer it with 3 of the slots open on both sides. It gives me a slightly restricted DL draw. The Loop V1.5 is capable of huge airflow with the afc completely open. It has a locking ring for the top cap so it won’t spin on your mod. You just adjust the airflow by turning the center.
The flavor is pretty good for a 24mm rda that is capable of dual or single coils. I believe smaller single coil 22mm rda’s has slightly better flavor. But as I stated above, the airflow is smooth, smooth, smooth. And it can chug the clouds!
I have to say it is a really good looking rda. I have dripped it on my Asmodus Minikin v2 as pictured & it has a deep juice well! I didn’t over drip not once.
It also has these holes under your coils so when you drip the wick gets soaked & the surplus drips down to the well.
I have also used it on my Hugo Squeezer bf mech mod & it also works very well. Haven’t overdripped as any excess juices goes back in your squonk bottle.
I have wicked with cotton & rayon & I prefer the flavor with the rayon. It tasted muted for me with the cotton.
