eleaf istick 60w TC

[Paul Allen]

Hola Compadres!!

I recently hooked my Dad up with an eleaf istick 60w tc, when it works, it works great, but he is constantly getting the "no atomizer" message on his display, he currently has the Nickel coil in the Melo 2 and the only way to clear this message is by taking the tank off and putting it back on. Has anyone had any issues with this?

 

[braveminion]

I had the Istick 30w and had no end of problems with it but my other half used and is still using the same one in a different colour with no issues. I never really looked into my issues because it was a great excuse to indulge my shinyitis.

It sounds like it is making a poor connection to the atomiser. Are either of the connections loose or tarnished? Is the contact being made firmly or would adjusting the bottom screw help?

Sent from my SM-G925F using Tapatalk

 

[Douggro]

Bit of a pain, but disassemble the tank and clean inside the base. Also check the center pin on the TC60 to make sure it's centered and not stuck down.
And make sure that he's locking the resistance of the Ni coil when it's at room temp.

 

[SpaceApe]

Did any of the suggestions resolve your issue?

 

[Paul Allen]

Hola everyone!! Hope those of you in the NE of the US are all dug out, I was stuck at a hotel all weekend...good times :/
@SpaceApe I checked his pin and just wiped it out a bit with a paper towel, so far no other issues that I am aware of.