So I've had my istick for 2 months now with no problems. The ego connector did stop working after a day, but that could be the connector. I've been using a nautilus mini almost this whole time with no problems. I just got my KFL+ clone and have been using it and loving the vape for the past few days. Then after refilling the RTA and putting it back on the istick it read that it had low ohms. I built the coil to be 1.4 and it was reading that for a couple days. When I unscrewed the kfl+ just a tad it read 1.4 but was alittle loose. When going back to nautilus it would read 0 ohms. I now have to screw my mini only halfway down for it to now read correctly. When I first got it I could put it on all the way without the loose space. Anyone know whats going on. It worked fine 2 days ago.
eleaf istick 20w ohms issue
- Thread starter fire123
- Start date
- th_trl_thread_readers 0
- Status
Does the iStick 20 have a "floating" center pin? If so, it may be that its coming loose. Which I think isn't very good as they seem to be quite hard to replace. But I don't own an iStick. Just a thought...
The kayfun sounds like it has a short, the coil could be touching some metal in the chimney or a post. Though, with the ego not working. That doesn't make any sense. I believe that the istick 20 positive pin isn't spring assisted, and using another tank could have pushed the pin down so that it's not touching. That could affect all your tanks. The Nautilus not being able to he screwed down all the way also leads me to believe that your positive pin in the 510 connector is screwed up somehow.
It may be the center pin of the battery is not making a solid connection with the atomizer of the clearomizer/tank. This usually occurs from over-tightening the tank onto the battery connector. Just make sure that if you use something conductive (metal) to pry up on the center pin that you do NOT hit the fire button while you are working on the battery. Or better yet, turn off the battery.
Center Pin Issue - Fixing a non firing eGo battery
Center Pin Issue - Fixing a non firing eGo battery
not sure about prying it up since my attys are shorting out the more I turn them down. My mini just days ago worked when the atty base met flush with the battery base. Now the mini reads 0 ohms when tightened that far. Could the battery center pin get pushed too far up?
ive been using the ohms reader on the istick for all by builds. Been using an igo l before the kayfun. It has always read my mini coils that are premade correctly as well. It has never done this as in change ohms as I screw the atty.
- Status
Similar threads
- Locked
