Drilling out an ehpro kayfun lite plus

[Asbestos4004]

I drilled one out to 3/32 and noticed a pretty big difference too....
BUT....
its not what they're designed for. KFL's, Russians and the like are tank systems that are an obvious improvement over pro tanks and other clearos. They're not drippers. Trying to get them to perform like a sub ohm dripper is fruitless. They can't possibly wick fast enough nor can they provide sufficient airflow for super low builds. They vape warm with standard builds. It is fun to see what we can get out of them but I've found the flavor and performance to be the best with a .9-1.4 ohm coil and cotton on a regulated mod.

 

[Hijack]

I bought then drilled out my KFL+ to 3/32 and use a 6mm wide bore tip. Made a really noticeable difference actually! Still it is not a really airy draw, but far better than stock.

This is what a lot have done and say it makes it far better.

 

[Ambassador]

Yes drilling it out does make the draw and vape much better. Def well worth it and will help with a lower build. However it's still no good according to most under 0.7 ohm. I'm running mine at 1.1 on a reg mod. Not yet tried anything lower. I do plan on trying a dual coil at around 0.8 at some point, but currently liking my Kraken at 0.5