Check atomizer

[Kalod]

hi all

I have a snow wolf with tfv4 tank
And i just bought uwell crown and when I connect it to my mod it say check atomizer
I took everything off and changed the coil and still the same
My mode cant read the resistance or like there is no atomizer at all
My smoke tank work fine
Any suggestions?

 

[Scy123]

tfv4's are known to have a long 510 connection. Maybe your tfv4 pushed the pin down and it's stuck or something. Try playing with the 510 pin on your mod.

 

[dcfluegel]

hi all

I have a snow wolf with tfv4 tank
And i just bought uwell crown and when I connect it to my mod it say check atomizer
I took everything off and changed the coil and still the same
My mode cant read the resistance or like there is no atomizer at all
My smoke tank work fine
Any suggestions?

Howdy! And welcome!

Sounds like the crown isn't making a good connection - I would check to make sure that firing pin on crown is not pushed up into base of the crown

Sent from Tapavapatalk

 

[suprtrkr]

+1. That's a connection issue. Clean the 510 well on the SW with a Q-Tip and rubbing alcohol, and make sure the center pin is free to move. Do not use a metal implement to move the pin; toothpick works. Check the Crown to make sure the center positive screw sticks down below the outer 510 negative threads. Welcome to the board.

 

[daviedog]

510 pins are not standardized in length. When attaching a new atty you will feel a slight resistance, stop. If you don't feel this & your atty bottoms out, you'll see the error message.
When adjusting positive pin, Turn device off..

 

[BrotherBob]

Welcome and glad you joined.

 

[DebiK]

I came in to say the same thing everyone else has, so I'll just say Welcome to ECF!

 

[EBates]

Welcome aboard