Just received my T3's in the mail this morning, and had a chance to give them a look..
Build quality looks great. The primary wick and coil is nested on the bottom:
On top, we have two strands of wick laid side by side, to provide additional vapor/flavor production:
These definitely
vape really nice, with some very stout clove
juice I dumped in..For sure a
From a cleaning/dryburning long term maintance standpoint, I only have one small issue. Due to the top two loose strands of wick, these will no doubt disintegrate upon first boil/soak/dryburn. I say this, only if you plan to take them apart to scrape the coils clean. If left intact, no problem. If rebuilding them is your forte', then it looks to be cakewalk IMO. Looks to be 2mm or 3mm wicking.
If I had divine influence with Kanger, I would like to see all three strands wrapped in the coil, as opposed to just the single, on the bottom.
Comparing them to the Phoenix BC's: Since I have my clove juice already in the Phoenix's, this was easy. On the first few vapes, the Phoenix's do out perform them. However, I feel after a tankfull or two, these will be right on par, if not better. Given the advantages of not having to syringe fill, combined with the extra juice capicity, these are a no brainer purchase. If you like the flavor of the T2's, but wish for a slightly cooler vape, these are the ticket.
Buy them, there really good.....
