Aspire K1 with BVC 1.6 Ohm - Leaking

Status
Not open for further replies.

Frontwave

New Member
Aug 2, 2016
4
0
51
Hello all, using this setup with some (edited) E-juice. It's fairly thick stuff but meant to be used in these tanks. I put 1ml in this tank. Had 2 different types so used 2 different tanks. 1 ml in each. Worked great for about half the tank. Went to use it and it seemed like the stuff was leaking out into the joint between the battery and the tank. Did this on BOTH setups. Had another tank I used, not as nice flavor and smaller clouds but it doesn't leak. All I want is a quality setup that does not leak. I'm not looking for huge clouds (edited) At over $25 per ml it's expensive stuff to lose due to leaks !! Any ideas here folks? Any recommendations ?
 
Last edited by a moderator:

Frontwave

New Member
Aug 2, 2016
4
0
51
Make sure your coil is screwed in good. Where are you paying over 25.00 per ml?

Well, it's a pretty good price considering what it is...........(edited)
I screw in the coil quite tight for sure. I read in another thread someone said you shouldn't screw it in hard, but only until it makes contact plus a quarter turn sorta thing but that makes no sense to me, seems a good tight connection is best. I also read that this tank likes to be full all the time, that once it's half empty you need to refill again. I'm starting to think I need to find an alternative......I also hate the small area where you need to load the juice in.......(edited)

Funny how my cheaper one works fine.....
 
Last edited by a moderator:

Frontwave

New Member
Aug 2, 2016
4
0
51
I use a K1 tank for my tobacco flavored juice and will sometimes notice the battery wet when taking the tank off that I just wipe off. How bad is your leaking?

It seemed like I lost a fair amount, I had about .75 ml left and when I went to use it again the next morning half of that had leaked out. I take care to always leave them upright at all times too......
 
Status
Not open for further replies.

Users who are viewing this thread