Aspire BDC ET-S gargle

Status
Not open for further replies.

Jake Court

Senior Member
ECF Veteran
Verified Member
ill start of by saying that im new. so this may be a dumb question and if it is please feel free to flame me. but i recently bought and aspire BDC et-s glassmizer it is on my ego type battery and it gargles some times. i was looking at it and realizing that the air holes are tiny. if i drill those out a little would it improve my gargling issue? and if it would what size should i drill it out?

thank you in advance.
 

Maestro

Super Member
ECF Veteran
Feb 19, 2012
912
1,141
Windsor, Ontario
I have 4 of them and have had almost no problems. These coils are know for gurgling when you get low on juice. I have this problem on the full size Aspires, but not on the ET-S, except every once in a while. Usually just means I have to take the tank off and clean out the well on the battery. Make sure your 0-rings are all still there and that the tank is nice and tight so you don't loose the vacuum. Also, don't draw too hard. It's best to refill when the juice gets down to the level of your atomizer.
 
Status
Not open for further replies.

Users who are viewing this thread