I have 2 new kits, willing to part with them, going for a mod...Seems I probably will be sorry because if there is a ban, the pipe...looks like a pipe, and draws no attention.
Edit=SOLD+
Edit=SOLD+
Last edited:
That is so funny you would say that. My pipe refuses to work when I try to show off how much vapor it can produce. It's very shy around strangers and non-believers.Dallas, what I've been noticing with my flavours is VG based wont flood the bowl because its thicker than PG but VG will tend to clog the vaccuum switch slighty more than PG. I feel its safe to assume the scientists in Shenzen were designing the Pipe601 to atomize the synthetic version of the glycerol and engineered the unit around the higher viscosity liquid than its vegetable counterpart.
I've also noticed when vaping at work that the Pipe601 is a karma-detector of sorts. It will just stop providing satisfying vapor just moments before I realize coworkers of bad karma are nearing proximity. Its as though Pipe601 doesnt want to share the goodtime with people of ill refute. i respect the wishes of Pipe601 and continue my vape session elsewhere with the grandest of satisfying results. Pipe 601 maybe my most loyal ally offering people forecasts before I even see the people; must be an ancient chinese secret.
I ordered the Ecopure 25mg menthol 15mil bottle today. That's some pricy stuff. At $15 for a 15mil bottle, that's a lot for a little.cignot.com markets for intellicig, they have a 25mg menthol in the ecopure section. Its a heavy tasting menthol; stronger than a salem but not quite a newport or kool.
I'm using cignot.com as my liquid vendor since they're local and I have it snail-mailed overnight to me; from chicago to texas its going to be a couple hub transfers. You may want to try it but if your local vendors' 24mg menthol is doing the job, you might want to keep patronizing your neighbor.
Has anybody here tried the original Ruyan 601 pipe? I know it's more expensive than the DSE601 pipe, but they say the DSE601 is a knock-off of the original Ruyan.
There is a thread or two here that compairs the two, and I've read the original 601 pipe from Ruyan is a higher quality pipe and will last a lot longer.
Ed.
I'm just dripping into my Pipe601s'. Neither perform well with the cartridges compared to the vapor I get when dripping; I expect the Pipe601 I should have delivered tomorrow will be the same performer. They do serve me exceedingly well; 3-5 drops on the atomizer is atleast a kingsize cigarette worth of vaping. I use the 1200 mah batteries at home and bring the 4 standard 900 mah to work with me. I usually swap out batteries to top-off-charge after 2 vape-breaks. I figure why run down the battery to the low voltage warning when I have plenty of batts. Tomorrow morning will be 2 weeks without analogs; which pays for my first Pipe601.
My atty stuck "on" today - could not get it to shut off. But it's 2 months old - right on time for some trouble. I pulled out the brass ring that holds the cover and hung the pipe in a cup with some tape to let it drain. There was a serious amount of juice in there. I'll let it drain for 24hrs and see if I can pull the battery compartment out.I made mine into a manual switch setup when the board failed.
The circuit board is actually on the side of the plastic bowl insert buried in white silicone.
The manual pressure switch fits under the atty against it.
If you flood the atty it goes right into the switch.
Worst case is if it stick from gooey eliquid and is considered a loss, fill it with 151 vodka or PGA (down the tube) let it sit for a few and tip it up and drain it. Repeat and blow & suck inbetween.
This will free most. Then hold the bowl, shake out all you can, dry down the tube with a blow dryer on hot for a few and let dry over night.
This has fixed many that give you no LED "on" when drawing.