What do you think for a dual 18650 with a Keystone sled:
1. Positive post to 510 pin: 14G
2. Source to Neg: 14G
3. Drain to Neg on 510: 14G
4. Gate to Switch: 24G
5. Positive to 510 pin and to Switch: 24G
6. If fused you could run 18G from Positive posts into 2,15amp fuses than 14G from fuses to 510 pin.
Using a IRLB3034 Mosfet with a 15K resistor.
I am too lazy and too dumb to understand the exact outputs of the Mosfet but trying to reduce wire size to a SAFE minimum. I never understand anything that Mamu posts so looking for "wiring for dummies."
From what I have read, the loads from the switch are the lowest so that wire size can be reduced mostly. Any diagrams for different wire sizing with these components would be great.
Thanks for any help.
1. Positive post to 510 pin: 14G
2. Source to Neg: 14G
3. Drain to Neg on 510: 14G
4. Gate to Switch: 24G
5. Positive to 510 pin and to Switch: 24G
6. If fused you could run 18G from Positive posts into 2,15amp fuses than 14G from fuses to 510 pin.
Using a IRLB3034 Mosfet with a 15K resistor.
I am too lazy and too dumb to understand the exact outputs of the Mosfet but trying to reduce wire size to a SAFE minimum. I never understand anything that Mamu posts so looking for "wiring for dummies."
From what I have read, the loads from the switch are the lowest so that wire size can be reduced mostly. Any diagrams for different wire sizing with these components would be great.
Thanks for any help.
