Needing some help here. I have a KEBO Russian 91% that I've had a couple months. I just noticed that the cross air hole on the center pin does not line up with the AFC hole of base with screw removed, regardless of rotation. Cross hole on center pin seems to be about 3/16" higher than AFC hole on base when upper deck down is tightened down with center pin installed.
With center pin removed, the cross hole on the pin is approximately .400" from bottom of pin. Using a dime for scale, the cross hole lines up with Eisenhower's nose. Is this correct for the R91.
Anyone have a stock KEBO Russian 91% center pin for comparison? Also wondering what's the difference on center pin for a full size Russian. I've contacted the vendor and they assure me that I have the correct pin that was supplied.
I've got 2 EHPRO KFL+ rba's, and the center pin cross hole lines up with AFC holes on both of them.
Any help with this issue is greatly appreciated.
With center pin removed, the cross hole on the pin is approximately .400" from bottom of pin. Using a dime for scale, the cross hole lines up with Eisenhower's nose. Is this correct for the R91.
Anyone have a stock KEBO Russian 91% center pin for comparison? Also wondering what's the difference on center pin for a full size Russian. I've contacted the vendor and they assure me that I have the correct pin that was supplied.
I've got 2 EHPRO KFL+ rba's, and the center pin cross hole lines up with AFC holes on both of them.
Any help with this issue is greatly appreciated.