Thanks, guys. I'll get one of these from the ebay guy. Any advice on how to make the pass through last longer? I was planning on putting electrical tape around where the cord goes into the LED to try and prevent the wire from coming loose. Any other suggestions?
wv2win If your getting the
Vaporguys USB Pass-Through You Don't have to tape it up, its a quality unit unlike most others I have tried.
I have several with no issues.
For Maintenance:
- Unplug it when not in use
- Do not wiggle / jiggle the USB connection
- Do Not Over Tighten The Connection, Try Using The Same Atomizer On It
- Hang the Threaded Connector End Down toward the floor When Not in Use
- Clean the Threaded Connections with Cotton Pad / Q-tips
- Do Not Allow or have the Pen Connected and left in the vertical direction
- Use your Pen but always put it down horizontally
- Temporary Storage with Atomizer Use The Horizontal Position
The Biggest Killer On A Good USB Pass-Through Is Juice Dripping Into The Switch In The Pass-Through Unit Itself, so heed above for the best.
The Cheaper USB Pass Throughs Units The Cord Does Come Out or Break in The End of it, A Small Piece of electrical tape is fine, but do not bend the wire over the end of it & tape it.
Hope This Helps
Keep Vapin!