Pyrex Tanks VS Plastic Tanks

[cocacola31173]

I have both a Smoktech DCT polyprothlene tank and a IBtanked tank. It seems to me though using the exact same kind of carto is it seems to feed the carto in the IBtanked better. It also seems like the draw gets tighter quicker on the Smoktech one then the IBtanked one.

IS this my imagination or has anyone else encountered this?

 

[Baditude]

I only use IBTanks.

My thoughts are from previous experience with Smoktech tanks (many months ago), the pyrex tanks have much better seals (o-rings) than the Smoktech tanks do. This probably allows for better negative pressure in the pyrex tanks than plastic ones, allowing for better wicking of the juice.

 

[cocacola31173]

That is what I was thinking. I only have 1 Ibtank but I will probably get a couple more at tax time. Do you have any of the 22 mm? And do they hold a lot more then the 19 mm? XL tube that is.

 

[Baditude]

Q: How much do the tanks hold?

A: Note that the below is approximate and we are conservative with our numbers. We do not count what goes into the cartomizer and leave a little room at the top but these are very good estimates on how much liquid our tanks will hold.

15mm HalfLing =
15mm Standard=
15mm XL =

19mm HalfLing = 0.7ml
19mm Standard= 1.5ml
19mm XL = 2ml

22mm HalfLing = 1.2ml
22mm Standard = 3ml
22mm XL = 4.5ml

25mm HalfLing = 2ml
25mm Standard = 5ml
25mm XL = 8ml

F.A.Q.