Making A New Nautilus Coil

[thetrucker]

Hi Fellow Vapers,

I made a new nautilus coil. I took the dual coil head and completely gutted the thing.

I then took a toothpick and twisted it in as far as I could into one of the empty holes where the

juice comes in and cut the tooth pick off up tite against the head with my wire cutters.

I then did the same thing with the opposite hole and cut off the tooth pick.

I took a small drill and drilled rite thru from one wick hole to the other.

I then made my coil by sliding a jewlers screwdriver thru the hole.

I made my wick and slid it thru and wet it good.

Used 32 guage with 5 wraps and it came out to 1.8 ohms.

Working ood no dry hits and no gurgling.

Had fun doing this nd just stumbled onto the tooth pick idea.

 

[WharfRat1976]

Pics?

 

[thetrucker]

Pic just came to my laptop from my telephone----and are in the next post below.....

 

[thetrucker]

Okay this is a 1.6 ohm dual coils Aspire head that I gutted completely and drilled with a small size bit.

I drilled all four holes and pressed a tooth pick into two opposing holes after cutting the tip off the tooth pic

This leaves me with 2 wooden plugs plugging 2 opposing holes.

I then slide jewlers screwdriver thru the hole and thru a small coil that I tied and put

grommet and pin back in.

made a cotton wick and slide threw and leave tails about one half inch long and litely tuck

the tails down into

the nautilus base and wet the coil good and put it all together and it works good. Single

horizontal coil. Whatever size you can fit in the hole will work, I used 28 guage with 5

wraps---comes out to .5 ohms------fun fooling around with this.