King Mod Issue

[charliehall72]

So last night I fell asleep with my king mod mephisto set up laying next to me. Had a .14 build in there and woke up this morning feeling something hot. I immediately grabbed the mod with my bare hand and burnt the hell out of it. I finally was able to take it apart and on top of the delrin insulator on the mephisto and the delrin super carb drip tip from ninja mods both completely melting, the delrin insulator on the floating pin in my king mod melted too. Anyone know where I could find a replacement for this?

 

[Bad Ninja]

Chi you flat top conversion piece would supply the insulator for the king.
They are only $5 or so.

 

[charliehall72]

I forgot to mention it's the original version of the king with the octagon rings on it so the insulator is pretty long

 

[BSN-671]

When I melted the delrin on my Knight RDA I just used an o ring in its place. It was a PITA when changing DT but it did the job. I believe I've slightly melted the delrin on my Mephisto as well. When I change DT it occasionally works its way out.

 

[jarreddizzle]

You should just contact Surefire Vapor, that's what I've always done.

 

[charliehall72]

Tried contacting surefire about 10 times total between facebook and email and have gotten no reply. Working on getting the mephisto replaced but not sure what I'll do about the king. Anyone know if theres a 1:1 king clone that I could switch out the delrin piece on?