Is it possible to build a well functioning RBA for a Cool Fire 1?

Status
Not open for further replies.

TheNarrator

Full Member
Jul 27, 2014
11
1
Utah
I have an Innokin Cool Fire 1, and I really like it. (Still a little afraid of mechs) I have a kayfun (Ehpro) lite +2, a Smoktech RSST and a Smoktech RSBT that I use on a Tesla and a Sigelei VMAX V5, and love it! I have become decently efficient at building micro-coils using 28g kanthal. I would really like to build another one for the Cool Fire 1. I have been using a Protank 3 and the Iclear 30b on the Cool Fire, both with coils around 2.0 ohms. They work great, but neither gives me the satisfaction of the RBA's. Common sense tells me that I can just build a 2.0 ohm micro-coil for the Cool Fire, but I am skeptical... RBA's and micro-coils are quite different from the standard off the shelf builds. Any suggestions on a coil build for the 8.5 watts of the Cool Fire? Is it even possible to build an RDA that will give me a good to very good vape on that device? Any and all suggestions would be greatly appreciated!
 

steved5600

Ultra Member
ECF Veteran
Verified Member
Sep 7, 2012
2,693
1,197
Dallas, Texas
You needed to spell out what satisfaction is. Could be flavor, clouds or TH. At 2ohms and 8.5 watts you should be able to get flavor but not much in the way of clouds or TH. I'd go with the Kayfun single coil do a 2.5mm Inside diameter or there about with organic cotton and my nifty calculator says it would be an 11/10 wrap w/28ga a1 kanthal. Your limited in what you can do by ohms and that it is a fixed 8.5 watts as i recall.
 
Status
Not open for further replies.

Users who are viewing this thread