Hi mate.
That is the base or the deck, not the "top", but I digress.
Remove the build. Fire the device. Any sparks?
The symptoms sound like an insulator problem or perhaps a poorly made clone.
What is the RDA?
How old is it?
Has it been used with builds below .15Ω?
Is the 510 screw tight?
Was the RDA recently washed?
Have you taken the unit to bits and inspected the components?
Welcome to the ECF.
Cheers
I
Hi Izan
I removed the build and there was no sparks (might be because the mod, I think it can notice if there is a build on or not). The mod just said "check atomizer".
The atomizer is hellvape's drop dead rda. And the mod is the Vaperesso gen mod(220w)
They are both about 4-5 months old.
The build have always been:
0,28 Ohm (26Gx2)*(36GA)
- Estimated resistance:
- Single coil: 0,24 ohm (±0,05 ohm)
- Dual coil: 0,12 ohm (±0,05 ohm)
. I usually vape on 60w
It havn't been recently washed no.
No i havn't taken the unit to bits and inspected the components
But I tightened the 510 as you asked if I did and removed the build and put it back. And it seems like the problem is fixed. But if you notice that there still might be a problem that might not be fixed by what I just wrote. Please write again.
Thx for the help