I posted this message in the other discount vapor thread, I think this thread might be more appropriate?
QUESTIONS FOR DISCOUNTVAPOR CUSTOMER SERVICE - TECH SUPPORT REP.
Have a few questions about this product on the discountvapers.com website, assuming any employees are familiar with and have actually used it!
Haka Meter Voltage/Ohms/Watts - Stainless
I just received this tester, and the bottom (the 510 threaded end you screw onto the mod), has a spring loaded pin, that's always GOOD. That PIN, has a split cut across it, more importantly wondering;
Why is this 510 pin HOLLOW?
(Seems in this design it should have been a SEALED pin, as it is not delivering AIR, or juice in the case of a bottom feeding mod like mine)
I'm "assuming" the entire meter body is SEALED, correct?
Using it to test voltage on a Reo mod, which is a bottom feeder, there is always a drop or more of juice in the 510 well, that can find its way onto and INTO the PIN of the meter, and can be hard to clean off, as you can't get below the spring loaded hollow pin, and juice can build up there, or worse get inside the meter if it's not totally sealed?
This may or may not be an issue, certainly not a big deal if my assumption that the meter is sealed everywhere else?
Until I hear back, I'm using a SEALED 510 adapter, WOULD PREFER NOT TO, as it adds even more length to a fairly long meter, but does not seem to effect the voltage reading at all.
There are a few other atty 510 meters on the web, but most are 22mm, what's separates this Haka meter is its ONLY 14mm's wide, and works on tiny top mods like a Reo Mini 14500. I have already recommended and posted a link to this product from your website in several Reo threads, but want get some feedback on my questions and concerns, listed above.
Thanks for your response.
QUESTIONS FOR DISCOUNTVAPOR CUSTOMER SERVICE - TECH SUPPORT REP.
Have a few questions about this product on the discountvapers.com website, assuming any employees are familiar with and have actually used it!
Haka Meter Voltage/Ohms/Watts - Stainless
I just received this tester, and the bottom (the 510 threaded end you screw onto the mod), has a spring loaded pin, that's always GOOD. That PIN, has a split cut across it, more importantly wondering;
Why is this 510 pin HOLLOW?
(Seems in this design it should have been a SEALED pin, as it is not delivering AIR, or juice in the case of a bottom feeding mod like mine)
I'm "assuming" the entire meter body is SEALED, correct?
Using it to test voltage on a Reo mod, which is a bottom feeder, there is always a drop or more of juice in the 510 well, that can find its way onto and INTO the PIN of the meter, and can be hard to clean off, as you can't get below the spring loaded hollow pin, and juice can build up there, or worse get inside the meter if it's not totally sealed?
This may or may not be an issue, certainly not a big deal if my assumption that the meter is sealed everywhere else?
Until I hear back, I'm using a SEALED 510 adapter, WOULD PREFER NOT TO, as it adds even more length to a fairly long meter, but does not seem to effect the voltage reading at all.
There are a few other atty 510 meters on the web, but most are 22mm, what's separates this Haka meter is its ONLY 14mm's wide, and works on tiny top mods like a Reo Mini 14500. I have already recommended and posted a link to this product from your website in several Reo threads, but want get some feedback on my questions and concerns, listed above.
Thanks for your response.