Aspire K1 Clearomizer, 1.5ml Bottom Vertical Coil, Pyrex
The Aspire K1 is a new generation clearomizer, which uses the Aspire Bottom Vertical Coil (BVC)technology. It is made of stainless steel with a pyrex glass tank, allowing you to use any juice without fear of damaging the tank. It has 1.5 ml capacity and is easy to fill or replace the coil.
The Aspire K1 BVC coils have improved longevity, and ensure clean flavor from your e-liquids and lots of vapor. To change to coil, simply unscrew the base of your Aspire K1, unscrew the old coil and screw in a new one. To fill, tilt at a slight angle and fill with 1.5 ml of e-liquid (be careful not to drip any e-liquid down the center tube, that is for airflow). Screw the base back on and set aside for a few moments to allow the coil to become fully saturated. Please note that the Aspire K1 is only compatible with Aspire K1 BVC coils, and NOT with Aspire Nautilus BVC coils.
The Aspire K1 is 510/eGo threaded and will work on all 510 threaded eGo batteris and Mod's without the need for an adapter. To use with 510 devices, you will need an eGo-510 connector. The Aspire K1 features a removable 510 drip tip.
The Aspire K1 comes pre-installed with a 1.8 ohm coil - recommended voltage range is 4.2-5.0V.
Dimensions: Height 72mm (2.8") (with drip tip installed) / Diameter 14.5mm (0.57")
Replacement BVC heads for the Aspire K1 are available below:
The Aspire K1 is a new generation clearomizer, which uses the Aspire Bottom Vertical Coil (BVC)technology. It is made of stainless steel with a pyrex glass tank, allowing you to use any juice without fear of damaging the tank. It has 1.5 ml capacity and is easy to fill or replace the coil.
The Aspire K1 BVC coils have improved longevity, and ensure clean flavor from your e-liquids and lots of vapor. To change to coil, simply unscrew the base of your Aspire K1, unscrew the old coil and screw in a new one. To fill, tilt at a slight angle and fill with 1.5 ml of e-liquid (be careful not to drip any e-liquid down the center tube, that is for airflow). Screw the base back on and set aside for a few moments to allow the coil to become fully saturated. Please note that the Aspire K1 is only compatible with Aspire K1 BVC coils, and NOT with Aspire Nautilus BVC coils.
The Aspire K1 is 510/eGo threaded and will work on all 510 threaded eGo batteris and Mod's without the need for an adapter. To use with 510 devices, you will need an eGo-510 connector. The Aspire K1 features a removable 510 drip tip.
The Aspire K1 comes pre-installed with a 1.8 ohm coil - recommended voltage range is 4.2-5.0V.
Dimensions: Height 72mm (2.8") (with drip tip installed) / Diameter 14.5mm (0.57")
Replacement BVC heads for the Aspire K1 are available below:
