I'm new into DIY coils and I've been experimenting with a couple of wires last few days, namely: Ka1 28ga, SS316L 26ga and the latest - Ka1 26ga which works the best for me so far in terms of flavor (2.5mm with 8 rounds gives me ~1ohm).
But, as the 26ga is a bit thick, I'm spending a lot of time trying to get the "perfect" coil.... I'm attaching below the tools I'm using and the best result I've got so far. That one took me almost 15 minutes of pulling and stretching and compressing....
So, I was wandering if there is a trick to get this wire compressed quicker?
But, as the 26ga is a bit thick, I'm spending a lot of time trying to get the "perfect" coil.... I'm attaching below the tools I'm using and the best result I've got so far. That one took me almost 15 minutes of pulling and stretching and compressing....
So, I was wandering if there is a trick to get this wire compressed quicker?