510 to 510 connector needed for dripping atomizer on a Provari (mini)?

[macmiddlebrooks]

Hello!

I'd like to try dripping with a 510 long-barrel atomizer on my new Provari mini, but am unsure if I need to also get a 510 to 510 connector (sealed) like this: Short 510 to 510 Sealed Adapter - Kidney Puncher. I've never tried dripping before and am currently using a carto/tank set-up. I read that it is recommended to use a drip shield to keep juice from going down into the provari's battery area. Does using a drip shield require the use of one these connectors to raise the shield up a bit? Thank you for your time and assistance,

Mac

 

[tmcase]

The Provari doesn't have a very deep well so a drip shield would be a good idea. I don't know how long your atty is but I'm sure it is shorter than a drip shield so that could be a problem. You might get around that with a long straight drip tip but then you'd have to take it off to drip your juice. The sealed adapter may raise the atty up enough so that you can get a reg drip tip on with a drip shield.

 

[Dj Xy]

When using a 510 with a drip shield you will need a short adapter or else the shield wont be able to do its job since 510's get air flow from the base which is where it will leak if you over drip.
Plus a shield looks better than a naked atomizer on any device.