Vision Spinner III coils

[Mary E Redmond]

I have both Vision Spinners II and Vision Spinner III. Although, my coils on my Vision Spinner II look almost identical to the one in my Vision Spinner III coils, they do not fit so are not interchangeable. I am having a hard time finding the coils for the Vision Spinner III. Can anyone help me?

 

[r77r7r]

The spinner is a just the battery and sold with different attys on top. Need you to look at the atty and give us a name or pict will do.
Welcome to the forum.

 

[Baditude]

I agree with r77r7r. "Spinner" is just the brand name for an eGo style battery. These batteries are sold by different vendors with different juice attachments on top.

Before giving advice about coils for your juice attachments, you need to figure out what "tanks" or juice attachments they are. Can you provide a link to where you purchased them?

 

[Mary E Redmond]

I agree with r77r7r. "Spinner" is just the brand name for an eGo style battery. These batteries are sold by different vendors with different juice attachments on top.

Before giving advice about coils for your juice attachments, you need to figure out what "tanks" or juice attachments they are. Can you provide a link to where you purchased them?

Here is a picture of the complete e-cig.

 

[Baditude]

Here is a picture of the complete e-cig.

There's not enough detail in your picture for me to make a positive identification of the tank. It "could" be a Kanger Protank or clone, but like I said I can't make a positive ID from the pic. Maybe someone else can provide better help.

 

[gandymarsh]

Looks like a Protank or clone to me also. Looks like a Protank II which uses different coils than the Protank III. The name should be engraved on the outside of the base.

 

[stols001]

Do you have the box? Can you post a picture of the box the tank came in?

Best of luck,

Anna

 

[BrotherBob]

I have both Vision Spinners II and Vision Spinner III. Although, my coils on my Vision Spinner II look almost identical to the one in my Vision Spinner III coils, they do not fit so are not interchangeable. I am having a hard time finding the coils for the Vision Spinner III. Can anyone help me?

Welcome and glad you joined.
One of these days you may get tired of the expense and effort replacing prebuilt coils and consider an RTA. If you can bend paper clips and thread a needle, you can build your own coils and wick them. It's that simple. All you need is wire and a round rod (small screw drivers work) with approximately 1/8 inch od.
Re: Wrapping Building Coils 101 For Beginners