Hi everyone I'm a new member and was wondering if anyone has experienced spitting liquid with the smok Rpm80? I'm using the conical rgc coils 0.17 ohm and vaping around 40w. I am constantly tasting the liquid rather than it spitting. I've done the usual clean the drip tip and using 80/20 vg mix. Any advice is more than welcome. Thanks in advance.
- Status
Hi Craig,
Just to confirm, you are using 80%PG 20%VG liquid, correct?
That juice may be too thin to work properly in that device.
Most pods suggest a 50/50 mix of VG/PG and are known to work well with blends up to about 75% VG.
How long did you smoke and how many per day?
What is the nicotine level of the juice you are using?
How long have you had the Smok device?
Have you tried a new coil or a different coil in the device?
Where are you located?
Cheers
I
Just to confirm, you are using 80%PG 20%VG liquid, correct?
That juice may be too thin to work properly in that device.
Most pods suggest a 50/50 mix of VG/PG and are known to work well with blends up to about 75% VG.
How long did you smoke and how many per day?
What is the nicotine level of the juice you are using?
How long have you had the Smok device?
Have you tried a new coil or a different coil in the device?
Where are you located?
Cheers
I
Hi thanks for replying.
Sorry I should have been clearer. Its 80vg/20pg so the mix should be viscous enough to work correctly.
3mg nicotine
Been using the device since yesterday after upgrading from the rpm40.
Not tried a new coil yet, no.
If drawing harder does not resolve the issue, you may need to increase the power to the coil also.
HTH
I
Thank you I'll try that and if that fails I will try a new coil.
I have the RPM80 and it sounds daft but if the tank starts gurgling I just blow down it and it usually clears the spitback or crank the wattage up a bit and take a few pulls till it clears...these are my goto devices and Ive never really had major problems with them.
- Status
